Yokogawa YFGW710 - Manual (Page 73)

<B1. Engineering>
B1-9
IM 01W01F01-01EN
B1.2.2.2 Registering YFGW710
Register YFGW7010 with the project database. For details on the registration procedure, refer to
C2, “Field Wireless Configurator” in Part C of this document.
After the registration, set the following YFGW710 parameters displayed on the page of the Net-
work Information tab in the right pane of the Main window of Field Wireless Configurator.
n Network Information Field
Table B1-2 Network Information Setting
Parameter name Setting value Remark
Network ID Enter the appropriate network ID (2 to 65535).
Specify 100 for the field wireless network in
Figure B1-2.
YFGW710 runs with the network ID speci-
fied here.
TIP
When the network ID is changed, provisioning of the field wireless device must be performed again.
n IPv4 Settings Field
Table B1-3 Configuring IPv4 Settings
Parameter name Setting value Remark
IP Address Set the values assigned to YFGW710 by the
wireless network engineering.
Specify the following for the field wireless
network in Figure B1-2.
IP Address: 192.168.0.101
Subnet mask : 255.255.255.0
Default Gateway: 192.168.0.1
Field Wireless Configurator accesses
YFGW710 specified here.
Subnet Mask
Default Gateway
NTP Server IP Address Specify the IP address of the NTP server. An NTP server is not commonly used, so
set the same IP address as the default
gateway.