Yokogawa YFGW710 - Manual (Page 70)

<B1. Engineering>
B1-6
IM 01W01F01-01EN
n Hardware Preparation
l YFGW710
l Field wireless device
l Two PCs
Provide two PCs, namely, one to install Field Wireless Configurator and Field Wireless Man-
agement Tool, and one to install Field Mate.
An Ethernet interface (100BASE-TX) is required for PC1 that is connected by Ethernet.
l HUB
n Preparation for Software
l Installing software
Before constructing a field wireless network, provide the following software and install them on
the PCs to be used.
• PC1
Field Wireless Configurator R1.02.00 or later
Field Wireless Management Tool R1.02.00 or later
This software is included on the DVD-ROM that is supplied with YFGW710. For the installa-
tion procedure, refer to Part C, “Wireless System Setting and Management Software” of this
document.
Microsoft .Net Framework 3.5 Service Pack 1 is required for Field Wireless Configurator and
Field Wireless Management Tool.
If Microsoft .NET Framework 3.5 Service Pack 1 is not installed on PC1, it will be installed
when the Field Wireless Configurator and Field Wireless Management Tool are installed.
For details, refer to “C2.2.2 Installation Procedure” or “C3.2.2 Installation Procedure” in Part
C.
If an old version of the Field Wireless Configurator or Field Wireless Management Tool is
installed on PC1, install this software to update it. For details, refer to “C.2.2.2 Installation
Procedure” and “C3.2.2 Installation Procedure” in Part C.
If you are using the Windows Server 2008 R2 operating system, Microsoft .NET Framework
3.5 Service Pack 1 is preinstalled but must also be enabled. For details on how to check
whether Service Pack 1 is enabled and how to enable it, refer to “TIP” in “C1. System Re-
quirements of Provided Software.”