Yokogawa YFGW710 - Manual (Page 93)

<B1. Engineering>
B1-29
IM 01W01F01-01EN
B1.2.6 Task of Setting and Adjusting Field Wireless Device
Parameters
The task of setting and adjusting the parameters of the field wireless device that has joined the
field wireless network is performed from PRM via YFGW710.
For details on the procedure, refer to the user's manuals of PRM.
*1
Note that this task can also be performed after the Task of Downloading the Process Data Com-
munication Definitions described later.
*1: User's Manuals of PRM
IM 33Y05Q10-11EN Plant Resource Manager Reference
IM 33Y05Q10-11EN Plant Resource Manager Installation Manual
IMPORTANT
When Yokogawa's host system is running, set and adjust the parameters of the field wireless
device from PRM.
When Yokogawa’s host system is not running, or when a non-Yokogawa host system is connect-
ed, the parameters can be set and adjusted using FieldMate.
B1.2.7 Task of Downloading the Process Data
Communication Definitions
Download the process data communication definitions described in section B1.2.2.5 to the field
wireless device. For details on the registration procedure, refer to C2, “Field Wireless Configura-
tor” in Part C of this document.
Note that this task can also be performed before the Task of Setting and Adjusting Field Wireless
Device Parameters in B1.2.6.
n Downloading the Process Data Communication Definitions
When downloading the process data communication definitions to the field wireless device, the
process data communication between the device and YFGW710 starts according to the informa-
tion specified in Table B1-9.
During the time from when the download is completed until the process data communication
starts, IOP is displayed for the target device in HMI of Yokogawa's host system.
n Countermeasures against Download Error
When a download error occurs while the process data communication definitions are being
downloaded to the device, one of the following is likely to be the cause.