Yokogawa YFGW710 - Manual (Page 137)

<C2. Field Wireless Configurator>
C2-16
IM 01W01F01-01EN
3) Editing Devices
To edit a device in a selected network:
1. In the Devices tab page of the main window, double-click on the device or select the desired
device in the device list and click .
2. The Edit Device window will open, with the two tabs: Device Information and Sampling data.
3. Edit the desired fields and click [OK] to save the changes.
TIP
If you wish to upload a configuration file in edit mode for a device that has non-standard sampling parameters or
Modbus registers defined, the system will request confirmation before loading a new file.
4) Removing Devices
To remove a device from a selected network, select the device in the Devices tab page of the
main window and click in the toolbar.
The system will request confirmation before deleting the device. Click [OK] to delete the device or
[Cancel] to abort the action.
l Modbus Configuration Tab
The Modbus Configuration tab page allows you to manage the Modbus Register Map for the
network ID selected in the Project Sections tree.
The tab consists of three sections:
• Available/Sampling Parameters
• Input Registers
• Holding Registers(this feature is currently disabled)
The Available/Sampling Parameters section displays a list of all the parameters of the devices
in the network selected in the Project Sections tree. The parameters defined for sampling are
displayed in bold.
Figure C 2-15