Yokogawa YFGW710 - Manual (Page 31)

<A3. YFGW710 Field Wireless Integrated Gateway>
A3-11
IM 01W01F01-01EN
IMPORTANT
The connection between the host system (CENTUM or STARDOM equipment and other applica-
tion PCs) and YFGW710 requires an optical to metal Ethernet converter. Prepare an appropriate
converter which matches respective communication specifications for converting 10BASE-
T/100BASE-TX and 100BASE-FX. The recommended model is SLX-5ES-2SC of SIXNET.
l Wiring
1. Pull the optical fiber network cable into YFGW710 through the cable ground for the network
cable.
2. Connect the optical fiber communication cable to the optical connector.
Do not bend the optical fiber communication cable at a tight angle; arrange it as shown in
the figure.
3. The optical fiber communication cable is composed of a pair of wires that are used sepa-
rately and exclusively for transmission and reception (TX/RX), as indicated on the internal
label of the pole of SC optical connector into YFGW710. Follow the indication on the label, if
shown. If there is no indication, you may connect them arbitrarily. The connection directions
can be changed easily in the optical converter of the host system.
NETWORK
SUPPLY
ANTENNA 50Ω
(Optional)
100Base-FX 100Base-FX
TX RX
Optical Fiber communication cable
SC Optical Connecter
Cable Gland for Network Cable
FA0309.ai
Fig. A 3-9 Connection of optical network cable