Yokogawa YFGW710 - Manual (Page 156)

<C3. Field Wireless Management Tool>
C3-2
IM 01W01F01-01EN
C3.2.2 Installation Procedure
Administrator rights are required to install the Field Wireless Management Tool.
Before installing the Field Wireless Management Tool, the Microsoft .NET framework 3.5 Service
Pack 1 must be installed on the PC.
If Microsoft .NET Framework 3.5 Service Pack 1 is not installed, install it according to the instruc-
tions given in the TIP below.
Follow the instructions in the TIP of “C1. System Requirements of Provided Software” to check if
Microsoft .NET Framework 3.5 Service Pack 1 is enabled under Windows Server 2008 R2.
If an old Field Wireless Management Tool is installed, following the instructions below will install
the new version on top of the old version.
Set the DVD-ROM on the PC, and proceed to the following folder on Explorer.
<DVD-ROM drive> \ Field Wireless Management Tool
Run the “setup.exe” file from the above folder, and follow the wizard instructions.
Figure C 3-1
TIP
If Microsoft .NET Framework 3.5 Service Pack 1 has not been installed, run “setup.exe” to start Microsoft .NET
Framework 3.5 Service Pack 1 installation. Accept the Microsoft License Agreement to start installation of Micro-
soft .NET Framework 3.5 Service Pack 1.
When Service Pack 1 installation is completed, installation of the Field Wireless Management Tool starts. Follow
the instructions given by the Wizard to complete installation.