NORD Drivesystems BU0700 - Manual (Page 100)

NORDAC SK 700E Operating Manual
100 Subject to technical alterations BU 0700 GB-1411
Parameter Setting value / Description / Note Available with option
P717 Current speed immer sichtbar
-9999 ... 9999 rpm Displays the actual motor speed calculated by the FI. Positive values are given for rotation in either
direction.
P718 ... - 01
... - 02
... - 03
Current set frequency always visible
-400 ... 400.0 Hz Displays the frequency specified by the setpoint. (see also 8.1 Setpoint processing)
... - 01 = Actual setpoint frequency from the setpoint source
... - 02 = Actual setpoint frequency following processing in the inverter status machine
... - 03 = Actual setpoint frequency after the frequency ramp
P719 Actual current always visible
0 ... 500.0 A Displays the actual output current.
P720 Actual torque current always visible
-500.0 ... 500.0 A Displays the actual calculated torque-developing output current.
-500,0 ... 500.0 A  Negative values = generator, positive values = motor.
P721 Actual field current always visible
-500.0 ... 500.0 A Displays the actual calculated field current.
P722 Current voltage always visible
0 ... 500 V Displays the actual voltage supplied by the inverter output.
P723 Voltage -d always visible
0 ... 500 V Displays the actual field voltage component.
P724 Voltage -q always visible
-500 ... 500 V Displays the actual torque voltage component.
P725 Current cos

always visible
0 ... 1.00 Displays the actual calculated power factor of the drive.
P726 Apparent power always visible
0.00 ... 300.00 kVA Displays the actual calculated apparent power.
P727 Effective power always visible
0.00 ... 300.00 kW Displays the actual calculated effective power.
P728 Input voltage always visible
0 ... 1000 V Displays the actual mains voltage at the FI input.
P729 Torque always visible
-400 ... 400 % Displays the actual calculated torque.
P730 Field always visible
0 ... 100 % Displays the actual field in the motor as calculated by the inverter.
P731 Actual parameter set always visible
0 ... 3 Displays the actual parameter set.
P732 Phase U current always visible
0.0 ... 500.0 A Displays the actual U phase current.
Note: This value can, due to the measurement procedure used even with symmetrical output currents,
deviate somewhat from the value in P719.