NORD Drivesystems BU0700 - Manual (Page 61)

5 Parameterisation
BU 0700 GB-1411 Subject to technical alterations 61
5 Parameterisation
There are four switchable parameter sets available during operation. All parameters are always visible. All parameters can be
adjusted "online".
Note:
As there are dependencies between the parameters, it is possible for invalid internal data and operating faults to be
generated temporarily. Only the inactive parameters should be adjusted during operation.
The individual parameters are combined in various parameter sets. The first digit of the parameter number indicates the
assignment to a menu group:
The following main functions are assigned to the menu groups:
Menu group No. Master function
Operating displays (P0--): For the selection of the physical units of the display value.
Basic parameters (P1--): Contain the basic inverter settings, e.g. switch on and switch off procedures
and, along with the motor data, are sufficient for standard applications.
Motor / characteristic curve
parameters
(P2--):
Settings for the motor-specific data, important for ISD current control, and
selection of characteristic curve during the setting of dynamic and static
boost.
Speed control (P3--):
(only with the special extension units:
PosiCon or Encoder)
Settings for the control parameters (current controller, speed controller, etc.)
with speed feedback.
Control clamps (P4--): Scaling of the analog inputs and outputs, determining the function of the
digital inputs and relay outputs, as well as control parameters.
Extra functions (P5--): Functions dealing with e.g. the interface, pulse frequency or error
acknowledgement.
Positioning parameters (P6--):
(only with the special extension unit:
PosiCon)
Positioning parameters for the PosiCon option  see BU 0710!
Information (P7--): Display of e.g. actual operating values, old error messages, device status
reports or software version.
P5--, P6-- and P7-- parameters Some parameters in these groups can be programmed and read in several
levels (arrays).
Note: Parameter P523 can be used to load the factory settings for all parameters at any time. This can be helpful,
e.g. during the commissioning of a frequency inverter whose parameters no longer correspond with the
factory settings.
Attention: All parameter settings will be lost, if P523= 1 is set and confirmed with "ENTER".
To safeguard the actual parameter settings, these can be transferred to the ControlBox or ParameterBox
memories.