Creating copy groups – HP XP P9500 Storage User Manual
Page 191
2.
From remote host 2, create a route list (Remote 2
→ Primary, and Remote 2 → Remote 1
routes).
3.
From remote host 2, establish inter-disk controller logical paths (Remote 2
→ Primary, and
Remote 2
→ Remote 1).
4.
From remote host 2, register a command device for the storage systems at remote site 2,
primary site, and remote site 1.
Creating copy groups
All copy groups must be created on the primary host.
1.
Define a Continuous Access Journal Z copy group between the primary site and remote site
1.
2.
Define a Continuous Access Journal Z copy group between the primary site and remote site
2.
For C/T ID (JNLG) in the Setting C/T ID Attributes panel, specify the value that was specified
for C/T ID (JNLG) for the Continuous Access Journal Z copy group between the primary site
and remote site 1.
Defining a 3DC Multi-Target (Cnt Ac-J Z x Cnt Ac-J Z) configuration
191