HP XP P9500 Storage - Manual (Page 47)

Table 9 List of functionalities dependent on the storage system (continued)
Related sections XP P9500 XP24000/XP20000 XP12000/XP10000 XP1024/XP128 Function name
copy groups
using the BCM
Monitor (BCM Monitor)”
(page 41)
10
“Functions that acquire
volume information”
(page 103) Yes Yes
11
Yes
11
Yes
11
Acquire volume
capacity when a
storage system is
being scanned
Legend:
Yes: Available
No: Not available
1
XP P9500 is the only storage system for which values other than 00 can be specified for path group IDs.
2
See the chapter about CLI commands in the HP XP P9000 for Business Continuity Manager Software Reference Guide.
3
N/A is displayed.
4
See the chapter about the ISPF panels in the HP XP P9000 for Business Continuity Manager Software Reference Guide.
5
Specification is invalid. For details, see the HP XP P9000 Continuous Access Synchronous for Mainframe Systems User
Guide.
6
See the chapter on data objects in the HP XP P9000 for Business Continuity Manager Software Reference Guide.
7
Combination of the Cnt Ac-J Z ATTIME suspend and Delta Resync functions cannot be combined.
8 QUICK mode cannot be specified.
9 See the HP XP P9000 for Business Continuity Manager Software Installation Guide
10 4x4x4 configurations are not supported.
11 Volume capacity cannot be acquired for remote scans and NG scans. In addition, if the P-VOL is an XP1024/XP128
Disk Array, XP12000/XP10000 Disk Array, or XP24000/XP20000 Disk Array volume and the S-VOL is an XP P9500
Disk Array volume, the volume capacity cannot be acquired even if a Remote Scan is performed on the S-VOL.
The unit (the differential-data management unit) that manages the differential data of a P-VOL and
an S-VOL can be specified in DIF UNIT in the Copy Group Attributes panel (for Cnt Ac-S Z/TCA).
Thus, the units vary for each of the following storage systems that are used:
•
XP1024/XP128 disk array
•
XP12000/XP10000 disk array, XP24000/XP20000 disk array, or XP P9500 disk array
For details about DIF UNIT in the Copy Group Attributes panel (Cnt Ac-S Z/TCA), see the HP XP
P9000 for Business Continuity Manager Software Reference Guide. For details about the difference
management unit, see the HP XP P9000 Continuous Access Synchronous for Mainframe User
Guide.
Storage system identification
Differences in storage system identification in Business Continuity Manager are described in the
following sections.
Identification on the XP1024/XP128 disk array and XP12000/XP10000 disk array
When the storage system is an XP1024/XP128 or XP12000/XP10000 disk array, Business
Continuity Manager considers the storage systems themselves to be storage systems and treats the
physical DKC serial numbers assigned to the individual storage systems as the storage systems
serial numbers.
Figure 8 (page 48) shows the storage system serial numbers for XP1024/XP128 disk arrays or
XP12000/XP10000 disk arrays.
Storage system identification 47