HP XP P9500 Storage - Manual (Page 577)

| |
| Double check Device Address Domain ID values before proceeding. |
| Press Enter to create the Copy Group, Cancel to cancel. |
| |
| F1=Help F12=Cancel |
'------------------------------------------------------------------'
4. Press the Enter key.
The Setting C/T ID Attributes panel displays.
5. Specify C/T ID (JNLG), Sub C/T ID (JNLG) and Path ID.
------------------------------------------------------------------.
| Setting C/T ID Attributes |
| Command ===>
|
| |
| C/T ID (JNLG) . . . . 0c (2-digit Hexadecimal) |
| Sub C/T ID (JNLG) . . 0c (2-digit Hexadecimal) |
| Path ID . . . . . . . 00 (2-digit Hexadecimal) |
| |
| |
| F1=Help F12=Cancel |
'------------------------------------------------------------------'
6. Press the Enter key to close the Setting C/T ID Attributes screen.
The Copy Group Pair Detail panel appears (in the initial state, no list of copy pairs appears
because no copy pair is defined at this point).
7. Press the F4=Attr key.
The Copy Group Attributes (CAJ) panel appears.
8. Specify copy group attributes (such as PROT MODE).
Be sure to leave Mirror ID set to 1.
.------------------------------------------------------------------.
| Copy Group Attributes (CAJ) |
| Command ===>
|
| |
| C/T ID (JNLG) . . . . 0C (2-digit Hexadecimal) |
| Sub C/T ID (JNLG) . . 0C (2-digit Hexadecimal) |
| Path ID . . . . . . . 00 (2-digit Hexadecimal) |
| MIRROR ID . . . . . . 1 (Decimal) |
| ERROR LVL . . . . . . GROUP (GROUP or VOLUME) |
| PROT MODE . . . . . . PROTECT (PROTECT or PERMIT) |
| C/T TIME MODE . . . . ASIS (JOURNAL, VOLUME or ASIS) |
| |
| |
| F1=Help F12=Cancel |
'------------------------------------------------------------------'
9. Press the Enter key.
The Copy Group Pair Detail panel appears.
Adding the copy pair to the copy group (Continuous Access Journal Z)
To add a copy pair to a copy group:
1.
Press the F5=Add key.
The Pair Selection List (Primary) panel displays.
Defining a copy group 577