Goulds Pumps 3196 i-FRAME - IOM - Manual (Page 104)

Maintenance
12. Install the shaft assembly into the bearing frame as follows (see the illustration):
a) Coat the outside of the bearing housing (134) with oil.
b) Coat all the internal surfaces of the bearing frame (228) with oil.
c) Install the shaft assembly into the bearing frame (228).
Make sure that the shaft rotates freely.
d) Install the clamp bolts (370C) in the bearing housing (134) and tighten by hand.
e) Install the jack bolts (370D) with the locknuts (423) in the bearing housing (134) and
tighten by hand.
Assemble the rotating element and the bearing frame (XLT-i and i17)
CAUTION:
• Wear insulated gloves when you use a bearing heater. Bearings get hot and can cause physical
injury.
• Use care when you handle the shaft because it can be heavy. Failure to do so could result in
personal injury.
NOTICE:Make sure that the pipe threads are clean, and that you apply thread sealant to the
plugs and fittings. Failure to do so may result in equipment damage or decreased performance.
NOTICE:Use an induction heater that heats as well as demagnetizes the bearings when you
install bearings. Failure to do so may result in decreased performance.
1. Prepare the bearing frame (228) as follows (see the illustration):
a) Install the oil-fill plug (113A).
b) Install the oil-drain plug (408A).
c) Install the sight glass (319).
d) Install the sight oiler plug (408J).
e) Install the plug for the oil-cooler inlet (408L).
f)
Install the plug for the oil-cooler outlet (408M).
102 Model 3196 i-FRAME Installation, Operation, and Maintenance Manual