Goulds Pumps 3196 i-FRAME - IOM - Manual (Page 80)

Maintenance
5. Remove the bearing housing O-ring (496).
6. Remove the clamp ring screws (236A) and separate the clamp ring (253B) from the bearing
housing (134).
You must remove the bearings before you can remove the clamp ring from the shaft.
7. Remove the bearing housing (134) and the bearings (112A and 168A) from the shaft (122).
8. Remove the inboard bearing (168A).
9. Remove the bearing locknut (136) and bearing lockwasher (382).
10. Remove the outboard bearings (112A).
NOTICE:Use force only on the inner race when you press bearings off the shaft. Do not
use force in situations in which you might break a part. Doing so may result in equipment
damage.
NOTICE:
Save the bearings for inspection. Do not reuse the bearings. Doing so may result in
decreased performance.
11. Remove the outboard labyrinth oil seal (332A) from the bearing housing (134).
78 Model 3196 i-FRAME Installation, Operation, and Maintenance Manual