Goulds Pumps 3196 i-FRAME - IOM - Manual (Page 85)

Maintenance
Disassemble the power end (XLT-i and i17 with duplex bearings)
1. Remove the bearing frame to frame foot (241) using the frame-foot bolts (370F).
2. Remove the clamp screws (370C) and back off the jam nuts (423).
3. Tighten the jack screws (370D) evenly to move the bearing housing (134) out of the bearing
frame (228A).
4. Remove the shaft assembly from the bearing frame (228A).
5. Remove the jack screws (370D) and the nuts (423).
6. Remove the bearing housing O-ring (496) and the inboard bearing (168A).
7. Remove the bolts (371C), the end cover (109A), and the gasket (360C).
8. If necessary, remove the outboard labyrinth oil seal (332A) from the end cover (109A) and
remove the O-rings (497F and 497G).
Model 3196 i-FRAME Installation, Operation, and Maintenance Manual 83