Goulds Pumps 3196 i-FRAME - IOM - Manual (Page 98)

Maintenance
e) Install the jack bolts (370D) with the locknuts (423) in the bearing housing (134) and
tighten by hand.
Assemble the rotating element and the bearing frame (STi and MTi with
duplex bearings)
CAUTION:
• Wear insulated gloves when you use a bearing heater. Bearings get hot and can cause physical
injury.
• Use care when you handle the shaft because it can be heavy. Failure to do so could result in
personal injury.
NOTICE:Make sure that the pipe threads are clean, and that you apply thread sealant to the
plugs and fittings. Failure to do so may result in equipment damage or decreased performance.
NOTICE:Use an induction heater that heats as well as demagnetizes the bearings when you
install bearings. Failure to do so may result in decreased performance.
1. Prepare the bearing frame (228) as follows (see the illustration):
a) Install the oil-fill plug (113A).
b) Install the oil-drain plug (408A).
c) Install the sight glass (319).
d) Install the sight oiler plug (408J).
e) Install the plug for the oil-cooler inlet (408L).
f)
Install the plug for the oil-cooler outlet (408M).
g) Install four oil-mist connection plugs (408H).
Or: Install two grease fittings (193) and two grease-relief plugs (113).
96 Model 3196 i-FRAME Installation, Operation, and Maintenance Manual