Goulds Pumps 3196 i-FRAME - IOM User Manual

Page 106

Advertising
background image

Maintenance

c) Put the bearing housing (134) onto the shaft.

Do not use force.

7. Fasten the gasket (360C) and the end cover (109A) with the bolts (371C).

See the specified torque values.
Make sure that the shaft rotates freely.

8. Install the inboard bearing as follows (see the illustration):

a) Coat the inner surfaces of the bearings with lubricant.
b) Put the inboard bearing (168) onto the shaft (122).

The regreasable bearing has a single shield. Make sure that the bearing is installed
with the shield away from the impeller.

9. Install the remaining parts onto the bearing shaft as follows (see the illustration):

a) Install a new O-ring (496).
b) Install the outboard labyrinth oil-seal (332A) into the end cover (109A).

Place the drain slots of the oil seal at the bottom position (6 o’clock).

104

Model 3196 i-FRAME Installation, Operation, and Maintenance Manual

Advertising