Goulds Pumps 3196 i-FRAME - IOM - Manual (Page 51)

Commissioning, Startup, Operation, and Shutdown
b) Place the driver half of the coupling guard over the pump half of the coupling guard.
The annular groove in the coupling guard half must face the motor.
6. Place the driver-side end plate over the motor shaft.
7. Place the driver-side end plate in the annular groove of the driver-half of the coupling
guard.
8. Use a bolt, a nut, and two washers to secure the coupling guard half to the end plate. Hand-
tighten only.
The hole is located on the driver-side of the coupling guard half.
Model 3196 i-FRAME Installation, Operation, and Maintenance Manual 49