Lenze EDK71MMXXX−010 - Manual (Page 104)

7
Commissioning
With hand terminal
EDK71MMXXX−010 DE/EN/FR 5.0
L
104
)
Note!
l Adhere to the switch−on sequence.
l In case of faults during commissioning, the chapter on "Troubleshooting"
provides support (
^ 128).
Switch−on sequence Comment
1. Connect hand terminal to AIF
interface
2. Ensure that the starttec is inhibited
after mains switch−on Terminal X3/28 = LOW
3. Switch on mains
4. Switch on 24−VDC supply
5. After approx. 2 s, the hand terminal
is in Disp" mode and displays the
apparent motor current (C0054)
start015
00 0
0054
000
1
c d
j g f k i h PS 
A
The
USEr
menu is active
6. Change to the
f
mode to set the
parameters of the drive
start016
00 0
0054 000
1
c d
j g f k i h PS 
A
w x
z
y
0054
flashes on the display
7. Scroll down on C0006
start037
00 0
0006 000
1
c d
j g f k i h PS 
A
w x
z
y 0006
flashes on the display
8. To change the setting of the
potentiometers or the stepping
switch using the hand terminal, set
C0006 accordingly
Lenze setting: −0− C0006 C0012 C0016 C0120 l PU: Potentiometer "U
o
"
for starting voltage
l PT: Potentiometer "T" for
acceleration time
l S: Stepping switch for
rated motor current
l H: Hand terminal
Important!
When switching to hand
terminal, the values set with
PU, PT and S are
transferred.
0 PT PU S
1 PT PU H
2 PT H S
3 PT H H
4 H PU S
5 H PU H
6 H H S
7 H H H