Lenze EDK71MMXXX−010 - Manual (Page 95)

Electrical installation
Connection of bus function module
5
EDK71MMXXX−010 DE/EN/FR 5.0
95
L
Control of starttec with PROFIBUS−DP FIF module
The control of starttec via PROFIBUS−DP FIF module is possible via control word FIF−CTRL1 and status
word FIF−STAT1.
The following bit assignment applies:
Bit Assignment of control word FIF−CTRL1 Assignment of status word FIF−STAT1
0 S1 Reserved
1 S2 Pulse inhibit (DCTRL1−IMP)
0 = power outputs released
1 = power outputs inhibited
2 Reserved Reserved
3 Reserved Reserved
4 Reserved Reserved
5 Reserved Reserved
6 Reserved Fixed 1
7 Reserved Controller inhibit (DCTRL1−CINH)
0 = controller released
1 = controller inhibited
8 Reserved Device status (DCTRL1−STAT*1 ... DCTRL1−STAT*6)
0001 = switch−on inhibit
0011 = operation inhibited
0110 = operation released
1000 = fault active
9 Controller inhibit (FIF−CTRL1−CINH)
0 = controller released
1 = controller inhibited
10 External fault (FIF−CTRL1−TRIP−SET)
11 Reset fault (FIF−CTRL1−TRIP−RESET)
0 = a bit change causes TRIP reset
12 Reserved Reserved
13 Reserved Reserved
14 Reserved Reserved
15 Reserved Ready for operation (DCTRL1−RDY)
0 = not ready for operation (fault)
1 = ready for operation (no fault)