Lenze EDK71MMXXX−010 - Manual (Page 108)

7
Commissioning
Code table
EDK71MMXXX−010 DE/EN/FR 5.0
L
108
Code IMPORTANT Setting options
No. Selection Lenze Designation
C0002
s
uSEr
(Cont.)
Restore delivery
state 1 Lenze setting
ð
PAR1 Restore delivery state in the
selected parameter set of
the drive controller
2 Lenze setting
ð
PAR2
3 Lenze setting
ð
PAR3
4 Lenze setting
ð
PAR4
31 Lenze setting
ð
FPAR1 Restore delivery state in the
fieldbus function module
61 Lenze setting
ð
PAR1 + FPAR1 Restore delivery state in the
selected parameter set of
the drive controller and in
the fieldbus function
module
62 Lenze setting
ð
PAR2 + FPAR1
61 Lenze setting
ð
PAR3 + FPAR1
62 Lenze setting
ð
PAR4 + FPAR1
Transfer
parameter sets
with keypad You can use the keypad to
transfer parameter sets to
other drive controllers.
During the transfer,
access to the parameters
via other channels is
inhibited!
Keypad
ð
drive controller Overwrite all available
parameter sets
(PAR1 ... PAR4, if necessary
FPAR1) with the
corresponding data of the
keypad
70 with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
10 with all other function modules
Keypad
ð
PAR1 (+ FPAR1) Overwrite the selected
parameter set and FPAR1, if
necessary, with the
corresponding data of the
keypad
71 with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
11 with all other function modules
Keypad
ð
PAR2 (+ FPAR1)
72 with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
12 with all other function modules