Lenze EDK71MMXXX−010 - Manual (Page 112)

7
Commissioning
Code table
EDK71MMXXX−010 DE/EN/FR 5.0
L
112
Code IMPORTANT Setting options
No. Selection Lenze Designation
C0015
s
Manual setting
of operating
mode 0 0 Automatic recognition of the
operating mode From software version
2.0 onwards
starttec recognises whether
the wiring was performed
for multi−motor operation or
for reversal of the rotation
direction. For operation with
a pole−changing motor or
with motors < 250 W, the
operating mode must be
set manually in C0015.
1 Ignoring the automatic recognition
Operating mode = operation with
one motor or multi−motor operation
2 Ignoring the automatic recognition
Operating mode = reversal or
operation with pole−changing motor This setting is essential
when operating with
motors < 250 W in the
operation mode
"reversal"! Otherwise,
the starttec may be
destroyed.
C0016 Starting voltage
U
0
0.0 {0.1 %} 100.0
= deactivated
acceleration
time
1 Motor 1 а а Accepts the value from
potentiometer "U
0
"
l If C0006 = 0, 1, 4, 5:
– Display only
l If C0006 = 2, 3, 6, 7:
– Starting voltage
adjustable via C0016
2 Motor 2 а а Accepts the value from
potentiometer "T"
l If C0006 = 0, 1, 4, 5:
– Display only
l If C0006 = 2, 3, 6, 7:
– Starting voltage
adjustable via C0016
C0040
v
Inhibit starttec 0 starttec inhibited (CINH) starttec can only be
released if X3/28 = HIGH
1 starttec released (CINH)
C0043
v
TRIP reset 0 Currently no fault Reset active fault with
C0043 = 0
1 Active fault
C0052 Service code Potentiometer "T" Changes only through
Lenze Service!