Lenze EDK71MMXXX−010 - Manual (Page 99)

Commissioning
Without hand terminal
7
EDK71MMXXX−010 DE/EN/FR 5.0
99
L
)
Note!
l Adhere to the switch−on sequence.
l In case of faults during commissioning, the chapter on "Troubleshooting"
provides support (
^ 128).
Switch−on sequence Comment
1. Ensure that the starttec is inhibited
after mains switch−on Terminal X3/28 = LOW
2. Switch on mains
3. Switch on 24−VDC supply
4. Release starttec Terminal X3/28 = HIGH
5. Release brake, if necessary Terminal X3/E3 = HIGH
6. Start the drive
Start motor 1 Terminal X3/E1 = HIGH
start013
CINH
E1
M
E3
t
tir tif
CINH Release starttec via
X3/28
E1 Start motor
M1 Voltage characteristic at
X1/1U, 1V, 1W (motor 1)
E3 Brake control at X1/B1,
B2
t ir Acceleration time
t if Deceleration time 0.5 s
(C0013)
7. The drive is now running