Lenze EDK71MMXXX−010 - Manual (Page 93)

Electrical installation
Connection of AS interface
5
EDK71MMXXX−010 DE/EN/FR 5.0
93
L
Configuration
Data bits to starttec:
In C0410 (selection 6, 7, 8), you can assign the data bits D0, D1 and D2 to internal digital signals.
Data bits from starttec:
In C0415, subcode 5 and 6, you can assign internal digital signals to data bits D0 and D1.
Example:
The starttec will be released via AS−I and a brake motor will then be started. The starttec will report
back the status of the motor and the brake via AS−I.
Data bits to starttec:
AS−I configuration starttec
parameter setting Comment
Bit Command
D0 Release/inhibit starttec C0410/10 = 6
D0 = 1:
starttec released
(requirement: terminal X3/28 = HIGH)
D0 = 0: starttec inhibited
D1 Start/stop motor C0410/1 = 7
D1 = 1: Start motor
D1 = 0: Stop motor
D2 Release/apply brake C0410/3 = 8
D2 = 1: Release brake
D2 = 0: Apply brake
Data bits from starttec:
AS−I configuration starttec
parameter setting Comment
Bit Message
D0 Status of motor C0415/5 = 3
D0 = 1: Motor is running
D0 = 0: Motor is stopped
D1 Status of brake C0415/6 = 5
D1 = 1: Brake is released
D1 = 0: Brake is applied