Lenze EDK71MMXXX−010 - Manual (Page 94)

5
Electrical installation
Connection of bus function module
EDK71MMXXX−010 DE/EN/FR 5.0
L
94
You can operate the starttec via FIF interface at the following bus systems:
Bus system Required Lenze FIF module
PROFIBUS−DP E82ZAFPC 001
INTERBUS E82ZAFIC 001
System bus (CAN) E82ZAFCC 001
DeviceNet E82ZAFVC 001
CANopen E82ZAFUC 001
LECOM−B (RS485) E82ZAFLC 001
)
Note!
l The mounting of an FIF module requires the mounting set E71ZJ001!
– Observe the mounting instructions accompanying the mounting set.
l Notes about the wiring of the bus function module can be found in the
mounting instructions accompanying the bus function module.
(
Stop!
During the operation with starttec, terminal 28 (controller inhibit) of the
function module is inactive! Release/inhibit is switched via terminal 28 of the
starttec.