Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 125)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 125
Chapter
8
Viewing Option Module Web Pages
This chapter provides instructions on how to monitor the PowerFlex 750-Series
drive and its EtherNet/IP option module by using the module’s web interface.
Future enhancements may result in option module web pages that look different
than the examples shown in this chapter.
Enabling the Option Module
Web Pages After the option module is configured and operating, you can view its web pages.
They present information about the module, the drive to which it is connected,
and the other DPI devices connected to the drive such as a HIM.
By default the option module web pages are disabled. To enable the option
module web pages, set
Device Parameter 26 - [Web Enable] to “1” (Enabled).
Viewing Web Pages in
Adapter Mode In Adapter mode, the option module can be configured to automatically send e-
mail messages to desired addresses when selected drive faults occur and/or are
cleared, and/or when the option module takes a communication or idle fault
action.
Bit 0 of Device Parameter 27 - [Web Features] can be used to protect the
configured settings. For more details, see Adapter Mode Configure E-mail
Notification Web Page on page 130 .
1. On a computer with access to the EtherNet/IP network on which the
drive/option module is installed, launch a web browser such as Microsoft™
Internet Explorer software, version 5.0 or later.
Topic Page
Enabling the Option Module Web Pages 125
Viewing Web Pages in Adapter Mode 125
Adapter Mode Process Display Pop-up Dialog Box 128
Adapter Mode TCP/IP Configuration Web Page 129
Adapter Mode Configure E-mail Notification Web Page 130
Adapter Mode Device Information Pages 133
Viewing Web Pages in Tap Mode 136
IMPORTANT Depending on its selected operating mode (Adapter or Tap), the option module
provides a unique set of web pages with different information.