Setting the operating mode, Setting the – Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module User Manual
Page 19
Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
19
Installing the Option Module
Chapter 2
Setting the Operating Mode
The option module can be operated in Adapter mode (default) or Tap mode. For
information about the operating modes, see
.
Before installing the option module, set its Operating Mode Jumper J4 (
)
for the desired mode of operation.
Figure 1 - Setting Operating Mode Jumper J4
TIP
If Operating Mode Jumper J4 is missing, the option module operates in the
Adapter mode.
IMPORTANT
A new jumper setting is recognized only when power is applied to the option
module, or the module is reset. If you change a jumper setting, cycle power to
the drive or reset the module to apply the change.
MODE
ADPTR
TA
P
J4
Adapter Mode
Jumper Position
(default)
Tap Mode
Jumper Position