Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 130)

130 Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
Chapter 8 Viewing Option Module Web Pages
Adapter Mode Configure E-
mail Notification Web Page The Adapter mode Configure E-mail Notification web page contains selections
and data fields for configuring the option module to automatically send e-mail
messages to desired addresses when selected types of events occur. To view this
web page, click the “Configure e-mail” link (highlighted in
Figure 41 ) in the
navigation pane.
Figure 41 - Example of Adapter Mode Configure E-mail Notification Web Page
By default, settings are not protected. After configuration, settings can be
protected by using
Device Parameter 27 - [Web Features] to set E-mail Cfg Bit 0
value to “0” (Disabled). To change a protected configuration, it must first be
unprotected by setting the E-mail Cfg Bit 0 value back to “1” (Enabled).
To configure e-mail notification, perform the following steps.
1. Click the desired check boxes corresponding to what you want to occur
that will send e-mail notification.
•
If you want e-mail notification only when specific faults or alarms
occur, click this radio button and enter the fault or alarm numbers in
the box.
• If you want e-mail notification only when all faults or alarms except
specific faults or alarms occur, click this radio button and enter the fault
or alarm numbers in the box.
2. Click the communication fault and/or idle fault check box if you want e-
mail notification when these faults occur.