Chapter 4, Configuring the i/o, Using rslinx classic software – Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module User Manual
Page 53
Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
53
Chapter
4
Configuring the I/O
This chapter provides instructions on how to configure a Rockwell Automation
ControlLogix controller to communicate with the option module and connected
PowerFlex drive.
For information on using a PLC-5, SLC 500, or MicroLogix 1100/1400
controller, see Controller Examples for EtherNet/IP Network Communications
with PowerFlex 750-Series Drives, publication 750COM-AT001.
Using RSLinx Classic Software
RSLinx Classic software, in all its variations (Lite, Gateway, OEM, and so forth), is
used to provide a communication link between the computer, network, and
controller. RSLinx Classic software requires its network-specific driver to be
configured before communication is established with network devices. To
configure the RSLinx driver, follow this procedure.
1.
Start RSLinx Classic software.
2.
From the Communications menu, choose Configure Drivers to display the
Configure Drivers dialog box.
3.
From the Available Driver Types pull-down menu, choose EtherNet/IP
Driver.
4.
Click Add New to display the Add New RSLinx Driver dialog box.
5.
Use the default name or type a name.
6.
Click OK.
The “Configure driver:” dialog box appears.
7.
Depending on your application, select either the browse local or remote
subnet option.
8.
Click OK.
Topic
Page
Uploading the Electronic Data Sheet (EDS) File