Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 26)

26 Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
Chapter 2 Installing the Option Module
Applying Power
Apply power to the drive. The option module receives its power from the drive.
When you apply power to the option module for the first time, its topmost status
indicator (‘PORT’ for Adapter mode or ‘OK’ for Tap mode) should be steady
green or flashing green after an initialization. If it is red, there is a problem. See
Chapter 7 , Troubleshooting.
Start-Up Status Indications
After power has been applied, the drive STS (status) indicator can be viewed on
the front of the drive and the option module status indicators can be viewed with
the drive cover open or removed (
Figure 7 ). The indicators operate differently in
Adapter mode than Tap mode. Depending on the operating mode, possible start-
up status indications are shown in
Table 1 or Table 2 respectively.
Figure 7 - Drive and Option Module Status Indicators
ATTENTION: Risk of equipment damage, injury, or death exists. Unpredictable
operation may occur if you fail to verify that parameter settings are compatible
with your application. Verify that settings are compatible with your application
before applying power to the drive.
➊
➋
➌
➎
0
5 4
9 3 8 2 7
1
6
0
5 4
9 3 8 2 7
1
6
0
5 4
9 3 8 2 7
1
6
➍
For possible start-up status
indications, see
Table 1 for
Adapter mode operation or
Table 2 for Tap mode operation.
Drive Control Pod
(drive shown with cover removed)