Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 27)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 27
Installing the Option Module Chapter 2
Table 1 - Adapter Mode – Drive and Option Module Start-Up Status Indications
After verifying correct operation, swing down the drive HIM bezel to its closed
position and install the drive cover. For more details on status indicator
operation, see
page 114 and page 115 .
Item Name Color State Description
Drive STS Indicator
➊ STS
(Status) Green Flashing Drive ready but not running, and no faults are present.
Steady Drive running, no faults are present.
Yellow Flashing When running, a type 2 (non-configurable) alarm condition exists –
drive continues to run. When stopped, a start inhibit condition exists
and the drive cannot be started (see drive parameter 933 - [Start
Inhibits]).
Steady A type 1 (user configurable) alarm condition exists, but the drive
continues to run.
Red Flashing A major fault has occurred. Drive will stop. Drive cannot be started
until fault condition is cleared.
Steady A non-resettable fault has occurred.
Red/
Yellow Flashing
Alternately A minor fault has occurred. Use drive parameter 950 - [Minor Flt
Config] to enable. If not enabled, acts like a major fault. When
running, the drive continues to run. System is brought to a stop under
system control. The fault must be cleared to continue.
Yellow/
Green Flashing
Alternately When running, a type 1 alarm exists.
Green/Red Flashing
Alternately Drive is updating.
Option Module Status Indicators—Adapter Mode
➋ PORT Green Flashing Normal operation. The option module is establishing an I/O
connection to the drive. It will turn steady green or red.
Steady Normal operation. The option module is properly connected and
communicating with the drive.
➌ MOD Green Flashing Normal operation. The option module is operating but is not
transferring I/O data to a controller.
Steady Normal operation. The option module is operating and transferring
I/O data to a controller.
➍ NET A Unlit Off Normal operation. DHCP is enabled or a valid IP address is not set.
Green Flashing Normal operation. DHCP is disabled, the option module is properly
connected, has an IP address, and is connected to an EtherNet/IP
network—but does not have an I/O connection.
Steady Normal operation. The option module is properly connected and
communicating on the network to a controller.
➎ NET B Unlit Off Normal operation. The option module is properly connected, but is
idle.
Green Flashing Normal operation. The option module is properly connected, DHCP is
enabled, and the option module is transmitting on the network.