Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 31)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 31
Chapter
3
Configuring the Option Module
This chapter provides instructions and information for setting the parameters to
configure the option module.
For a list of parameters, see Appendix B , Option Module Parameters. For
definitions of terms in this chapter, see the Glossary .
Configuration Tools The option module stores parameters and other information in its own
nonvolatile storage (NVS) memory. You must, therefore, access the option
module to view and edit its parameters. The following tools can be used to access
the option module parameters.
Topic Page
Configuration Tools 31
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM to Access Parameters 32
Setting the Option Module Node Address 32
Setting the Data Rate 38
Selecting Master-Slave or Peer-to-Peer Hierarchy (Adapter mode only) 39
Setting a Fault Action (Adapter mode only) 46
Setting Web Page Access 48
Resetting the Option Module 49
Restoring Option Module Parameters to Factory Defaults 50
Viewing the Option Module Status Using Parameters 51
Updating the Option Module Firmware 52
Tool See
PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM page 32
BOOTP Server or DHCP server page 32
DriveExplorer Software,
version 6.01 or later http://www.ab.com/drives/driveexplorer , or
DriveExplorer online help (installed with the software)
DriveExecutive Software,
version 5.01 or later http://www.ab.com/drives/drivetools , or
DriveExecutive online help (installed with the software)
IMPORTANT For the HIM screens shown throughout this chapter, the option module was
installed in drive Port 4. If your option module is installed in a different drive
port, that port would appear instead of Port 4.