Rockwell Automation 1756-HIST2G Historian ME 2.1 - Manual (Page 127)

7 • T RANSFERRING D ATA
117
Viewing FactoryTalk Historian SE Information
The FactoryTalk Historian SE Information section provides the following
information:

FTHSE Licensed Points - FactoryTalk Historian ME scans the FactoryTalk
Historian SE server you set in the Data Transfer window to determine the total
number of FactoryTalk Historian SE licensed points reserved to the FactoryTalk
Historian ME.

"FTMS" Available Points - represents the number of FTHSE Licensed Points
minus the total number of points already tagged for transfer. This includes tagged
points from all modules that are set up to transfer data to the same FactoryTalk
Historian SE server. It takes approximately fifteen minutes to update the
FactoryTalk Historian SE server, so the “FTMS” Available Points value may not
update immediately when you click [Search]
Viewing FactoryTalk Historian ME Information
The FactoryTalk Historian ME Information section lists the number of points
selected, the number of newly added points, and whether Auto Transfer mode is
enabled or not.
Adding Points to Transfer
The table lists all points that fit the search criteria. If the point has been created in the
FactoryTalk Historian SE server, this is indicated in the table. All checked points are
tagged for transfer to the FactoryTalk Historian SE server.
The table lists the following information:

Selected - adds the point to Data Transfer. Points that have already been added are
checked also.

Name - name of the data point in FactoryTalk Historian ME.

Type - the data type of the point.

Source - indicates the point source of the data point.

Created in SE - the point has already been matched to the FactoryTalk Historian
SE server, as indicated by Y in the Created in SE column. If not, this is indicated
by N.