Rockwell Automation 1756-HIST2G Historian ME 2.1 - Manual (Page 183)

9 • M ANAGING S ECURITY
173
.
To test the module’s connection to the FactoryTalk Historian SE server where the
webs and datatransfer trusts you just created reside
1. Go to the FactoryTalk Historian SE Parameters section.
2. Enter the host name or IP address of your FactoryTalk Historian SE server in the
Host Server field.
3. Click [Test Connection].
An informational message that states, “The connection to SE was established.”
will display at the top of the page if the connection is successful. In addition, a
green checkmark will display next to the [Test Connection] button. This indicates
that the module can establish a connection to you FactoryTalk Historian SE
server.
4. Click [Save].
You have completed the trust configuration process.
Ensure that licenses
to support the FTMS
point source have
been activated on the
FactoryTalk
Historian SE server
before you configure
Data Transfer.