Rockwell Automation 1794-OF8IH FLEX Isolated Input/Output HART Analog Modules - Manual (Page 125)

Publication 1794-UM065B-EN-E - September 2010
Additional HART Protocol Information 113
68 Trim analog output
gain 0 Analog output number
code — — As in command —
1 Analog output units
code
2…5 Externally measured
analog output level (F)
69 Write analog output
transfer function 0 Analog output number
code — — As in command —
1 Analog output transfer
function code
70 Read analog output
end point values 0 Analog output number
code — 0 Analog output number
code —
1 Analog output end
point units code
2…5 Analog output upper
end point value
6…9 Analog output lower
end point value
107 Write burst mode
transmitter variables
(for Command #33) 0 Transmitter variable
code for slot 0 — — As in command —
1 Transmitter variable
code for slot 1
2 Transmitter variable
code for slot 2
3 Transmitter variable
code for slot 3
108 Write burst mode
command number 0 Burst mode command
number — — As in command —
109 Burst mode control 0 Burst mode control
code (0 = exit, 1 =
enter) — — As in command —
Common Practice Commands
Command Data in Command Data in Reply
# Function Byte Data
Type
(5) Byte Data
Type
(5)