Rockwell Automation 1794-OF8IH FLEX Isolated Input/Output HART Analog Modules - Manual (Page 36)

Publication 1794-UM065B-EN-E - September 2010
24 Install Your FLEX I/O Analog Modules
Connections for the 1794-OF8IH HART Analog Output Module on a
1794-TB3 or 1794-TB3S Terminal Base Unit
Ground the Module
Chapter Summary In this chapter, we told you how to install your input module in an existing
programmable controller system and how to wire to the terminal base units.
Go to the next chapter to learn about input, output and configuration files for
HART analog I/O modules on ControlNet and EtherNet networks.
ATTENTION
Do not use the unused terminals on the terminal base unit. Using
these terminals as supporting terminals can result in damage to the
module and/or unintended operation of your system.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
18 19 20 21 22 23 33 24 25 26 27 28 29 30 31 32 17
35 36 37 38 47 48 49 50 34 51
16
39 40 41 42 43 44 45 46
44319x
Row A
Row B
Row C
Row B
Row C
Row A
1794-TB3S shown
Label placed at top of wiring area
Actuator Actuator Actuator
IN0 IN1 IN2 IN3
8 C H HART ISOLATED A
N A LOG INPUT 1794-xx8iH I/O
IN4 IN5 IN6 IN7 PWR
3
44398