Rockwell Automation 1794-OF8IH FLEX Isolated Input/Output HART Analog Modules - Manual (Page 29)

Publication 1794-UM065B-EN-E - September 2010
Install Your FLEX I/O Analog Modules 17
4. Position the terminal base at a slight angle and hooked over the top of
the 35 x 7.5mm DIN rail A
(Allen Bradley part number 199-DR1)
5. Slide the terminal base over tight against the adapter (or proceeding
terminal base). Make sure the hook on the terminal base slides under the
edge of the adapter (or proceeding terminal base) and the FLEXbus
connector is fully retracted.
6. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
Use caution to make sure that the female flexbus connector does
not strike any of the pins in the mating male connector.
ATTENTION
Do not force the terminal base into the adjacent modules. Forcing the
units together can bend or break the hook and allow the units to
separate and break communication over the backplane.
A
A
41106
41107