Rockwell Automation 1794-OF8IH FLEX Isolated Input/Output HART Analog Modules - Manual (Page 31)

Publication 1794-UM065B-EN-E - September 2010
Install Your FLEX I/O Analog Modules 19
Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.
To install the mounting plate on a wall or panel:
1. Lay out the required points on the wall/panel as shown in the drilling
dimension drawing.
4
1
2
(35.5)
1.4
41547
3
Description Description
1 Mounting plate for adapter 3 Terminal base unit (not included)
2 #6 Self-tapping screws 4 Adapter module (not included)
35.5
(1.4)
15.6
(0.61)
58.5
(2.3) 40.5
(1.6)
8 (0.3)
35.5
(1.4) 58.5
(2.3) 35.5
(1.4)
0.83 (21)
50
(2.0)
Measurements are in mm (in.)
40871
TIP
Cable is either 292.1 mm (11.5 in.) or 901.0 mm (35.5 in.) from upper
connector — depending if you use 0.3 m (1 ft) or 0.91 m (3 ft) cable.