ClearOne Converge Pro - Manual (Page 109)

104
This display is identical to that shown on the Channel Tab when the channel is selected in the Tree View pane.
NOTE: Changes to channel configuration settings made in the channel routing matrix apply
globally to the channel. For example, changing the label (name) from “Output 1” to
“Ceiling Speakers” changes the name of the output channel in the Tree View pane, and
everywhere else the label appears in Console.
Beamforming Microphone Channel
Beamforming Configuration is used to define the mode and pickup zones of the selected Beamforming Microphone
Array.
Click on the Beam Forming Configure button on the Channel control of a selected Beamforming Microphone
Array.
Beamforming Microphone Orientation
Shown below is a configuration with Ceiling Mount as the selected mode. It displays the zones where the
microphones in the array pick up audio when the microphone array is mounted from the ceiling. (Table Mount and
Wall Mount modes will be available with a future firmware upgrade.)
The Auto mode allows the Beamforming Microphone Array to select it’s own mode by referencing a built-in
accelerometer that senses the position of the microphone array. However, this is not displayed in the Console.
Zone Disabling
Clicking on the checkbox associated with a zone in a mode will disable that zone, removing it from microphone
pickup. This is useful in customizing the zone to the room conditions where the Beamforming Microphone Array is
used.