ClearOne Converge Pro - Manual (Page 173)

168
Clear Matrix Button
Press the Clear Matrix button to clear ALL current matrix settings. A Confirm dialog appears asking you to confirm
the clear matrix operation. Use caution when using this feature because the operation cannot be undone.
Audio Routing Matrix
The numbers and letters along the top and left side of the matrix show the cross point coordinates. The Labels for
each channel are also shown to make them easy to identify. As you move the cursor over the matrix, the labels for
the channels are highlighted in white for each cross point.
NOTE: Clicking on a channel label opens the Channel screen for that channel, allowing you to
modify the channel label and change channel configuration settings as needed.
Input Routing
To route an input to an output, click in the routing matrix at the intersection between the input and the output. A mic
input can be designated as gated (yellow), non-gated (blue), or pre-AEC (brown) by clicking repeatedly in the cross
point. All other input cross points will be colored green.
Expansion Bus I–Z Routing
Audio from any unit on the E-bus network can be placed on the bus or taken off the bus and routed to any
destination within the unit.
All models have 18 digital mix-minus buses:
• S–Z Buses: These eight audio buses are line input mixer buses. They are used to route auxiliary audio, such
as from a CD player or VCR, to and from other units on the network. These buses are also used as mic mixer
buses when NOM count is not required.
• I–R Buses: These ten audio buses are generally used for routing microphone audio between CONVERGE/
CONVERGE Pro devices. Information about the number of gated microphones (NOM count) and other
relevant information for the microphone mixers are tracked for microphones routed to these buses. By
default, all microphones are routed to the O bus.