Dell POWEREDGE M1000E - Manual (Page 235)

Fabric OS MIB Reference 215
53-1002750-01
Connectivity unit group
9
connUnitPortFCClassOp
1.3.6.1.3.94.1.10.1.5 Read only Bit mask that specifies the classes of service that are currently
operational. If this is not applicable, return all bits set to 0. This object
has the same definition as connUnitPortFCClassCap.
For an F_Port or FL_Port, this value is 0x000C. For a G_Port or E_Port,
this value is 0x000D.
For a Brocade Access Gateway both the F_Port and N_Port this value is
0x0008. A Brocade Access Gateway supports class-three services only,
therefore the value is 8 for both port types.
connUnitPortFCClassOp is independent of the state of the port (online or
offline). Its value is only dependent on the port type.
connUnitPortState
1.3.6.1.3.94.1.10.1.6 Read only The state of the port hardware.
Possible values are:
•
unavailable (1) - Do not use.
•
online (2) - Available for meaningful work.
•
offline (3) - Not available for meaningful work.
•
bypassed (4) - No longer used.
•
diagnostics (5) - Map to your testing. (Not supported in Fabric OS
v2.6.1.)
For an E, F, or FL_Port, the value is online. For a U_Port, the value is
offline (disabled, testing, faulted).
connUnitPortStatus
1.3.6.1.3.94.1.10.1.7 Read only An overall protocol status for the port. For a U_Port, the status should be
ols (9).
Possible values are:
•
unknown (1)
•
unused (2) - Device cannot report this status.
•
ready (3) - FCAL Loop or FCPH Link reset protocol initialization has
completed.
•
warning (4) - Do not use.
•
failure (5) - Port is faulty.
•
notparticipating (6) - Loop not participating and does not have a
loop address. Do not use.
•
initializing (7) - Protocol is proceeding. Do not use.
•
bypass (8) - Do not use.
•
ols (9) - FCP offline status. (Not supported in Fabric OS v2.6.1.)
NOTE: In Fabric OS v2.6.x, for an E_Port, F_Port, or FL_Port, the value is
3 (ok). For a U_Port, the value is 2 (unused) if not faulty with
GBIC, 1(unknown) if not faulty but no GBIC, or 5 (failure) if faulty.
In Fabric OS v3.x and later, for an E_Port, F_Port, FL_Port or
other Port and online port state, the value is 3 (ok). For G_Port or
other Port and offline port state, the value is 9 (ols). For
unknown portype and offline port state, the value is 1
(unknown).
TABLE 75
Object and OID Access Description