Dell POWEREDGE M1000E - Manual (Page 61)

Fabric OS MIB Reference 41
53-1002750-01
IP group
2
ipRouteMetric1
1.3.6.1.2.1.4.21.1.3 Read-write The primary routing metric for this route.
The semantics of this metric are determined by the routing protocol
specified in the route's ipRouteProto value. If this metric is not used, its
value should be set to -1.
ipRouteMetric2
1.3.6.1.2.1.4.21.1.4 Read-write An alternate routing metric for this route.
The semantics of this metric are determined by the routing protocol
specified in the route's ipRouteProto value. If this metric is not used, its
value should be set to -1.
ipRouteMetric3
1.3.6.1.2.1.4.21.1.5 Read-write An alternate routing metric for this route.
The semantics of this metric are determined by the routing protocol
specified in the route's ipRouteProto value. If this metric is not used, its
value should be set to -1.
ipRouteMetric4
1.3.6.1.2.1.4.21.1.6 Read-write An alternate routing metric for this route.
The semantics of this metric are determined by the routing protocol
specified in the route's ipRouteProto value. If this metric is not used, its
value should be set to -1.
ipRouteNextHop
1.3.6.1.2.1.4.21.1.7 Read-write The IP address of the next hop of this route. (In the case of a route bound to
an interface that is realized through a broadcast media, the value of this
field is the agent’s IP address on that interface.)
ipRouteType
1.3.6.1.2.1.4.21.1.8 Read-write The type of route. Setting this object to 2 (invalid) has the effect of
invalidating the corresponding entry in the ipRouteTable object. That is, it
effectively dissasociates the destination identified with said entry from the
route identified with said entry. It is an implementation-specific matter as to
whether the agent removes an invalidated entry from the table. Accordingly,
management stations must be prepared to receive tabular information
from agents that corresponds to entries not currently in use. Proper
interpretation of such entries requires examination of the relevant
ipRouteType object.
Valid values:
•
other (1) - None of the following
•
invalid (2) - An invalidated route—route to directly
•
direct (3) - Connected (sub) network—route to a non-local
•
indirect (4) - Host/network/subnetwork
The values direct (3) and indirect (4) refer to the notion of direct and
indirect routing in the IP architecture.
ipRouteProto
1.3.6.1.2.1.4.21.1.9 Read only The routing mechanism by which this route was learned.
Inclusion of values for gateway routing protocols is not intended to imply
that hosts should support those protocols.
ipRouteAge
1.3.6.1.2.1.4.21.1.10 Read-write The number of seconds since this route was last updated or otherwise
determined to be correct.
Older semantics cannot be implied except through knowledge of the routing
protocol by which the route was learned.
NOTE: This object is not supported.
TABLE 11
Object and OID Access Description