Dell POWEREDGE M1000E - Manual (Page 241)

Fabric OS MIB Reference 221
53-1002750-01
Connectivity unit group
9
connUnitEventTable
1.3.6.1.3.94.1.11 Not
accessible The table of connectivity unit events. Errors, warnings, and information
should be reported in this table.
This table contains the 1024 most-recent event log entries.
Only external RASlog messages are supported. Fabric OS v4.4.0 and
later releases do not have Panic or Debug level messages. All external
messages are documented in the Fabric OS Message Reference.
connUnitEventEntry
1.3.6.1.3.94.1.11.1 Not
accessible Each entry contains information on a specific event for the given
connectivity unit.
connUnitEventUnitId
1.3.6.1.3.94.1.11.1.1 Read only The connUnitId of the connectivity unit that contains this event table.
Same as connUnitId.
connUnitEventIndex
1.3.6.1.3.94.1.11.1.2 Read only Each connectivity unit has its own event buffer. As it wraps, it might write
over previous events. This object is an index into the buffer. It is
recommended that this table is read using “getNext”s to retrieve the
initial table. The management application should read the event table at
periodic intervals and then determine if any new entries were added by
comparing the last known index value with the current highest index
value. The management application should then update its copy of the
event table. If the read interval is too long, it is possible that there might
be events that might not be contained in the agent's internal event
buffer.
An agent might read events 50-75.
At the next read interval, connUnitEventCurrID is 189. If the
management application tries to read event index 76 and the agent's
internal buffer is 100 entries maximum, event index 76 is no longer
available.
The index value is an incrementing integer starting from 1 every time
there is a table reset. On table reset, all contents are emptied and all
indices are set to 0. When an event is added to the table, the event is
assigned the next-higher integer value than the last item entered into
the table. If the index value reaches its maximum value, the next item
entered causes the index value to roll over and start at 1 again.
Mapped to swEventIndex.
connUnitEventId
1.3.6.1.3.94.1.11.1.3 Read only The internal event ID. Incriminated for each event, ranging between 0
and connUnitMaxEvents. Not used as table index to simplify the agent
implementation. When this reaches the end of the range specified by
connUnitMaxEvents, the ID rolls over to start at 0. This value is set back
to 0 at reset. The relationship of this value to the index is that internal
event ID might represent a smaller number than a 32-bit integer (for
example, maximum 100 entries) and would only have a value range up
to connUnitMaxEvents.
connUnitREventTime
1.3.6.1.3.94.1.11.1.4 Read only This is the real time when the event occurred. It has the following format.
DDMMYYYY HHMMSS
Where:
DD = day number
MM = month number
YYYY = year
HH = hours
MM = minutes
SS = seconds
If not applicable, returns a null string.
TABLE 75
Object and OID Access Description