Dell POWEREDGE M1000E - Manual (Page 40)

20 Fabric OS MIB Reference
53-1002750-01
Firmware upgrades and enabled traps
1
Firmware upgrades and enabled traps
The pre-Fabric OS v4.4 firmware had trap group level settings (for example, traps were turned on
and off as a group). In Fabric OS v4.4 or later, you can turn on and off traps individually within a
trap group. When you upgrade to the Fabric OS v4.4 firmware or later, by default the individual
traps are turned off even if the corresponding trap group was enabled before upgrading. You must
use the snmpconfig command to turn on explicitly the individual traps within each trap group.
Fabric OS commands for configuring SNMP
Use the following commands ( Table 5 ) to configure MIBs in the Fabric OS. For procedures for
configuring SNMP on the Brocade switches, refer to the Fabric OS Administrator’s Guide.
For more information about the commands, either refer to Table 6 or the Fabric OS Command
Reference.
FE-MIB No Disabled in Access Gateway because the conventions are specific to
fabric switches.
CPQ-Rack MIB Limited Supported on embedded switches only.
FCIP MIB No Disabled in Access Gateway because the conventions are specific to
fabric switches.
iSCSI MIB No Disabled in Access Gateway because the conventions are specific to
fabric switches.
IF-MIB Yes Supported in Access Gateway.
BD-MIB Yes Supported for F-ports.
IEEE 802.3 LAG MIB No Supported in Access Gateway.
IEEE 802.1x PAE MIB No Supported in Access Gateway.
LLDP MIB No Supported in Access Gateway.
BRIDGE-MIB No Supported in Access Gateway.
RMON-MIB Yes Supported in Access Gateway.
FA-Ext Yes Supported in Access Gateway.
SNMPv2 MIB Yes Supported in Access Gateway.
TABLE 4 Access Gateway MIB support (Continued)
MIB name Supported Description
TABLE 5 Commands for configuring SNMP
Command Description
snmpConfig This command has all the features of the existing agtcfg* commands; in addition, it has
SNMPv3 configuration parameters.
Enhanced in Fabric OS v6.3.0 to support SNMP Informs for SNMPv3 users.
Enhanced in Fabric OS v6.4.0 to support option-based mibcapability behavior.
snmpTraps This command supports the SNMP notification generator feature, Notification generator
framework has been implemented to send various SNMP traps.