Dell POWEREDGE M1000E - Manual (Page 239)

Fabric OS MIB Reference 219
53-1002750-01
Connectivity unit group
9
connUnitPortControl
1.3.6.1.3.94.1.10.1.16
(continued) Read-write
•
Return values are:
- resetConnUnitPort portDisable (F or E_Port, loop for U_Port)
- bypassConnUnitPort portDisable (FL_Port)
- unbypassConnUnitPort portEnable (FL_Port)
- offlineConnUnitPort portDisable (E, F, FL_Port)
- onlineConnUnitPort portEnable (U)
- resetConnUnitPortCounters clear the port statistics counter. - -
when rebooted, this defaults to 1 (unknown).
connUnitPortName
1.3.6.1.3.94.1.10.1.17 Read-write A string describing the addressed port.
NOTE: This object is read only for Brocade switches.
connUnitPortPhysicalNu
mber
1.3.6.1.3.94.1.10.1.18 Read only This is the internal port number by which this port is known. In many
implementations, this should be the same as connUnitPortIndex. Some
implementations might have an internal port representation not
compatible with the rules for table indices. In these cases, provide the
internal representation of this port in this object. This value might also
be used in the connUnitLinkPortNumberX or connUnitLinkPortNumberY
objects of the connUnitLinkTable.
The internal port numbers for Brocade switch. The Brocade switches
support 0 through maximum number of ports.
The maximum number of supported ports are as follows.
Brocade 300 24 ports
Brocade 4100 32 ports
Brocade 4900 64 ports
Brocade 5000 32 ports
Brocade 5100 40 ports
Brocade 5300 80 ports
Brocade 7500 or 7500E 32 ports
Brocade 7600 16 ports
Brocade 7800 Extension Switch 24 ports
Brocade 8000 32 ports
Brocade Encryption Switch 32 ports
Brocade DCX 640 ports
Brocade DCX-4S 320 ports
Brocade 48000 384 ports
Brocade 6505 24 ports
Brocade 6510 48 ports
Brocade 6520 96 ports
Brocade DCX 8510-4 Backbone 320 ports
Brocade DCX 8510-8 Backbone 640 ports
Brocade VA-40FC 40 ports
connUnitPortStatObject
1.3.6.1.3.94.1.10.1.19 Read only This OID is deprecated.
This contains the OID of the first object of the table that contains the
statistics for this particular port. If this has a value of 0, then there are
no statistics available for this port. The port type information helps
identify the statistics objects found in the table. From this point, use the
getnext command to get the next statistics object. When the first part of
the OID changes, the end of table is reached.
Mapped to connUnitPortStatFabricUnitId.
TABLE 75
Object and OID Access Description