Dell POWEREDGE M1000E - Manual (Page 321)

Fabric OS MIB Reference 301
53-1002750-01
LLDP-EXT-DOT3-MIB
16
lldpXdot3 remote data group
TABLE 115
object and OID Access Description
lldpXdot3RemoteData
1.0.8802.1.1.2.1.5.462
3.1.3 Not
accessible IEEE 802.3 remote devices information.
lldpXdot3RemPortTable
1.0.8802.1.1.2.1.5.462
3.1.3.1 Not
accessible This table contains Ethernet port information (as a part of the LLDP 802.3
organizational extension) of the remote system.
lldpXdot3RemPortEntry
1.0.8802.1.1.2.1.5.462
3.1.3.1.1 Not
accessible The information about a particular physical network connection.
lldpXdot3RemPortAutoN
egSupported
1.0.8802.1.1.2.1.5.462
3.1.3.1.1.1 Read only The truth value used to indicate whether the given port (associated with
remote system) supports auto-negotiation.
lldpXdot3RemPortAutoN
egEnabled
1.0.8802.1.1.2.1.5.462
3.1.3.1.1.2 Read only The truth value used to indicate whether port auto-negotiation is enabled
on the given port associated with the remote system.
lldpXdot3RemPortAutoN
egAdvertisedCap
1.0.8802.1.1.2.1.5.462
3.1.3.1.1.3 Read only This object contains the value (bitmap) of the
ifMauAutoNegCapAdvertisedBits object (defined in IETF RFC 3636) which
is associated with the given port on the remote system.
lldpXdot3RemPortOperM
auType
1.0.8802.1.1.2.1.5.462
3.1.3.1.1.4 Read only An integer value that indicates the operational MAU type of the sending
device.
lldpXdot3RemPowerTabl
e
1.0.8802.1.1.2.1.5.462
3.1.3.2 Not
accessible This table contains power Ethernet information of the remote system.
NOTE: This table is not supported.
lldpXdot3RemLinkAggTa
ble
1.0.8802.1.1.2.1.5.462
3.1.3.3 Not
accessible This table contains port link aggregation information (as a part of the
LLDP 802.3 organizational extension) of the remote system.
lldpXdot3RemLinkAggEn
try
1.0.8802.1.1.2.1.5.462
3.1.3.3.1 Not
accessible The link aggregation information about remote system's port component.
lldpXdot3RemLinkAggSt
atus
1.0.8802.1.1.2.1.5.462
3.1.3.3.1.1 Read only The bitmap value contains the link aggregation capabilities and the
current aggregation status of the link.
lldpXdot3RemLinkAggPo
rtId
1.0.8802.1.1.2.1.5.462
3.1.3.3.1.2 Read only This object contains the IEEE 802.3 aggregated port identifier, aAggPortID
(IEEE 802.3-2002, 30.7.2.1.1), derived from the ifNumber of the ifIndex
for the port component associated with the remote system.
If the remote port is not in link aggregation state and if it does not support
link aggregation, this value should be zero.