CANOGA PERKINS 9140 Four-Port SNMP Managed Fast Ethernet Switch - Manual (Page 15)

EdgeAccess SNMP Managed Fast Ethernet Switch
Model 9135/9140 1-5
1. 4 Quick Start Interface DIP Switch Settings
Although the 10/100BASE-TX UTP interface is factory configured for auto negotiation, it is recommended
that the configuration of each individual interface be confirmed prior to the connection of the 9135 Two-
Port Switch or 9140 Four-Port Switch to any equipment. The fixed speed 10BASE-FL and 100BASE-FX
fiber interfaces are configured for full-duplex operation (reference Table 1-1 for factory default settings).
The 10/100BASE-TX UTP interface (see Figure 1-4) can be configured manually or set for auto
negotiation mode. The various modes of operation include:
• Auto Negotiation
• 10Mbps Half-duplex and Full-duplex
• 100Mbps Half-duplex and Full-duplex
Table 1-1. Interface Default Settings.
UTP 100 FX 10 FL
SW Position SW1-1 SW1-2 SW1-3 SW1-4 SW2 SW1-1 SW1-2 SW2-1 SW2-2 SW1 W1
100BASE ON
FULL-DUPLEX ON ON ON
AUT ON
LL ENABLE ON ON
LOW POW ON
CROSS OVER X
SQUELCH JP X *
X = cross over switch is in the X position
X * = jumper is not installed
Note: Since the 9140 is a Four-Port device and LLF is designed to operate with two ports, interfaces
inserted into the 9140 with LLF enabled will function normally but will have LLF disabled.
Figure 1-4. 9135/9140 UTP and Fiber Interfaces and Connectors .
Formatted: Bullets and Numbering
Deleted: 3
Deleted: Page of 871