CANOGA PERKINS 9140 Four-Port SNMP Managed Fast Ethernet Switch - Manual (Page 75)

EdgeAccess SNMP Managed Fast Ethernet Switch
Model 9135/9140 5-29
7. Start the FTP Client (for details, see the documentation for the client software), then change to the
directory were the upgrade is currently stored.
8. To start the download, enter "ftp xxx.xxx.x.xx" where xxx.xxx.x.xx is the IP address for the 9135 or
9140.
9. At the prompt for the User, enter "supervisor" in lower case, then at the prompt for the password, either
enter the password for the 9135 or 9140 supervisor access or, if no password has been set, enter
"password." You must enter a password, even if no password is set.
Note: If the login fails, enter "quit" and then restart the FTP client or enter "user" and repeat
Step 8.
10. At the prompt, type "dir" and check the file names for the Active and Inactive software. These are the
versions in the active and inactive Flash memory.
11. At the prompt, enter "binary" to enable the file transfer format.
Note: To view the file transfer progress, type "hash".
12. To start the transfer, type "put 9135XXXX.IMG" or "9140XXXX.IMG" where XXXX is the version
number.
13. When the transfer is complete, "Requested file action successful" appears. At the prompt, enter "quit"
to close the FTP connection.
14. To invoke the new software version, reset the unit. To verify this, return to the Description screen.
The new Software Revision is in the active location and the old version remains in the inactive Flash
location.
Deleted: Page of 871