CANOGA PERKINS 9140 Four-Port SNMP Managed Fast Ethernet Switch - Manual (Page 55)

EdgeAccess SNMP Managed Fast Ethernet Switch
Model 9135/9140 5-9
After you have selected the desired field to change, the current selection will become highlighted. Press the
<Tab> key to scroll through available options.
The following options are available for each of the possible configurable options shown on figure 5-11:
• Interface: select either "direct" or "modem"
• Init Modem at Startup: select "yes" or "no"
• Modem Init String: the default Init String is ats0=1 (Advanced users only)
• Password enable: select "yes" or "no"
• SLIP Password: select a password of up to 15 characters
•
SLIP IP Address: enter the IP address of the Serial Line Interface Port. The SLIP address and the in-
band address must have different network IDs and cannot reside on the same network.
• SLIP Subnet Mask: enter the SLIP Subnet Mask
• SLIP Port Setup: select number 8, <Enter> and a new menu will be displayed that details the
configuration of the SLIP Port. Enter the values shown in Figure 5-12.
Figure
5 -12. SLIP Port Setup.
5.2.1.4 Passwords
The 9135 Two-Port Switch and the 9140 Four-Port Switch has three levels of password protection:
• Supervisor highest level, can do anything
• Manager middle level, has some write access
• User mostly read-only access, can reset some counters
When entering a new password, you may select up to 18 characters. All letters, numbers and characters are
legal and your new password will be case sensitive. Reference Figure 5-13.
Formatted
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Deleted:
Deleted: Page of 871