CANOGA PERKINS 9140 Four-Port SNMP Managed Fast Ethernet Switch - Manual (Page 53)

EdgeAccess SNMP Managed Fast Ethernet Switch
Model 9135/9140 5-7
• Enable BOOTP Mode: BOOTP must be enabled if the Management Module needs to obtain its
IP address from a BOOTP server. If BOOTP is enabled, BOOTP requests are broadcast
periodically to the local network until a reply is received or the operator selects the Esc key as
prompted to continue. BOOTP can be disabled once the IP address is known.
•
Static ARP: lists the IP address, MAC address, and port for each permanently installed manager.
If the Host IP information is listed, the 9135 or 9140 will not issue ARP requests.
• Main Menu: this will take you back to the main Menu.
5.2.1.2
Host Table / SNMP Settings
Host Table and SNMP Settings can be configured to determine which traps are sent to pre-determined
Network Manager Stations. Certain IP addresses can be selected and configured as to the access level for
each host, i.e., Read, Write, receive traps, or any combination of the latter. A Trap Community is defined
by default as "public" for the Read Community, and "private" for the Write Community, however, these
settings can be changed from this menu. See Figure 5-9.
Figure 5 -9. Host Table and
SNMP Settings Menu.
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Deleted:
Deleted: Page of 871