CANOGA PERKINS 9140 Four-Port SNMP Managed Fast Ethernet Switch - Manual (Page 32)

3-6
3.2.3 100BASE-FX Single Mode Module
This is a plug-in module, which contains the 100BASE-FX Single Mode interface Figure 3-6.
The interface components are the following:
• SC/ST connector
• Port LEDs
• Tx Transmit (Green)
• Lnk Link (Green)
• Col Collision (Yellow)
• Fdx Half/Full-Duplex (Green)
• Rx Receive (Green)
• Rmtf Remote fault indication (Red) [Managed Units Only]
• Par Partition/Disable (Red)
• Llf Link Loss Forwarding/Enabled (Green) (Disabled on 9140)
• Connectors: Edge connector to the main board unit
Figure 3 -6. 100BASE FX Single Mode Module.
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted